By Kingwie

A majority of hot tub water incur chemistry problems because of the improper diagnosis with test strips. Some people think that just by dipping them into the water, they will get an accurate prognosis of what’s wrong with the hot tub water.

There is some truth to that. You can actually troubleshoot hot tub or spa problems on your own. The important thing you should be aware of is how to diagnose these properly and the steps you must take in order to fix or repair the hot tub water problem.

Hot Tubs Water

For future resources, here is a run through of the possible solutions to water chemistry problems in the hot tub or spa.

1. You should always make sure that your hot tub water is safe. You may get a lot of tips online claiming that the safest hot tub water is less stringent. Nonetheless, it is highly recommended that the water be reduced to a low point in order for your family and yourself to enjoy your hot tub safely.

2. Purchase the chemicals you will need for your hot tub water from the best store. Get them in pristine condition. Just make sure that you read the details of each chemical before you actually put it in your hot tub.

3. You have to test the chlorine levels of your hot tub water and make sure that they fall in the range of 3 to 5 mg for every liter. This is the required dosage for every hot tub. Test the pH levels and check whether they are between the range of 7.2 to 7.6. If it doesn’t, then you have to toggle the hot tub pH content and meet these figures. If the water foams, then use the anti-foam. You can also go for the diluted form which comes in spray bottles. Spray them on the surface of the water.

4. You should put oxidizing agents like Calcium Hypochlorite or Non chlorine in your hot tub water once every week. These clean the filter. You should also have spare filters which you use whenever you dry one. Notice that the fibers of the filter are bound together after you clean them.

Things to Remember if you have a Hot Tub

1. Calcium Hardness

You have to get the right calcium level in your hot tub water. The calcium levels depend on the source of hot tub water, where you get your supply and where you live. Soft hot tub water has low calcium while hard water has higher calcium. Each time you refill the tub with water, you have to check the calcium level.

Ideally, the calcium level that is appropriate for a tub ranges between 100 up to 200 mg for every liter. If the calcium level for ypur hot tub water is less than this, then it might result in damage or corrosion. If you find that the level of calcium is lower than the range mentioned, then use products such as the Hot Tub Hardness Plus in order to increase the calcium level up to the ideal.

If the level of your hot tub water is way above than the ideal, then the results will be cloudy water. You can deposit the excess calcium on the heater element, tub shell, filter cartridge or in the pipe. You can also use the product No Scale in order to bring it to the calcium level you prefer.

2. Alkalinity

This depends on where you get your hot tub water. You should always check whether fresh water has been added. Ideally, Alkalinity for the hot tub water ranges between 125 up to 500 mg per liter. If this stays in this range, then the water doesn’t fluctuate. If it drops, then the water becomes corrosive and causes damage on the equipment. We therefore suggest you use the product pH plus in order to increase the alkaline level.

However, if the alkaline level is higher than the ideal, then the water is not that clear and scales slowly form. In order to reduce this, we recommend ph Minus.

3. pH Levels

It’s important that you check the hot tub water ph level on a regular basis. Use the Test Strips that you can buy over the counter at your local drug stores. Ideally, the pH range equates 7.4 up to 7.6. The alkaline protects the equipment and provides an ideal condition for the users because of its sanitizing effect.

The Warm Hot Tubs Water

There are two types of hot tubs or spa i.e. in ground and portable. Some of them have contoured seating, others have lounger part that allow you to recline fully on it when it is fill up with the warm hot tubs water.

Hot Tubs Water

Hot tubs with a lounger will perfectly fit for those who have back or join pain since they can lay back on the lounger. Non lounger bath tubs or spa are suitable for relaxing or sitting in a group. Every hot tub and spa will have jet action to give the users the therapeutic effect out of it.

Generally, people will get hot tubs or spa due to their back problems. A hot soak in a spa full of warm hot tubs water along with jet massaging one’s entire body would be very comforting. However, hot tubs or spa could also be entertaining. Bigger hot tubs will allow family members along with guests to gather together in a cozy atmosphere. Having our self in a spa filled with warm hot tubs water after a stressful day of hard work would be very relaxing. The warm water and therapeutic effect from the jet seems to melt our stress away.

Unfortunately, not everybody could afford to buy or have hot tubs or spas due to their expensive price and maintenance. Not to mention the cost for a hot tub repair if there is any necessary one.

Recently, a lot of vendors offer many kinds of hot tubs. These may vary according to their color, material, features, number of jets and of course the size. Purchasing a hot tub will need extra thinking, consideration as well as funding.

If you could not afford to purchase it, you still can enjoy it in a certain spa centre around your city. Spa centre business is rapidly growth now in many capital cities. This will allow ordinary people who could not afford to buy a hot tub to enjoy a hot tub privately. Of course it will cost them a couple of dollars in return.